Well if it were anyone else that had posted it I would probably question it as well but the guy is a pretty straight shooter.
Nice. He also said that he was using this lens which was about an extra 50mW difference over a G-1/2 at 3W.
Last edited by DTR; 06-10-2012 at 10:07.
Hi all,
DTR is very helpful, providing lots of tech support & answers to my many questions.
I am building a 445nm laser module based on one of the 12mm Combo modules he sells.
As it is going to be the B in a RGB lasershow projector, I need capability for continuous duty cycle.
DTR helpfully suggested that the laser diode module would benefit from cooling, & the FlexMod P3 is easier to heatsink rather than a tiny driver meant to go in an Aixiz module.
I am trying to find a supplier for the fan cooled finned heatsink in DTRs photos & video. Does anyone have any ideas?
Also anyone recognise the laser power meter shown? Is it a Ardinuo module/shield?
Hope someone can help!
Many thanks,
Simon B.
Try these, they also have 3mm threaded holes for mounting 40mm fans on top.
http://www.innovam.com/en/produit_en...ier_en=HS-12en
I got mine here but I think he is out of them.
http://laserpointerforums.com/f39/ma...-hs-50590.html
I have really relied on mine for testing modules as it is really easy to swap modules in and out quickly.
Strange I clicked on it and it says it can not resolve this link then I click on it again and it works. Try this..
http://tinyurl.com/8x6v6qy