First off I want to say a big Thank you to Daniel Briggs. Daniel has written a manual that describes how to set up a "Laser PC" and iPad so that you can run our laser controllers from an iPad, iPhone, iPod... even Android devices will work (I have an EVO 3D that it works well with). I have been using this method with a different PC VNC server for over 2 years with very few issues. By doing this you are setting up a server on your Laser PC that is allowing your iPad to remotely control your Laser PC's desktop.
I know this has been discussed in a few threads, but I wanted to open a new thread to showcase Daniel's work.
I have attached the PDF version of the manual to this thread.
Enjoy!