ILDA Saftey Board 120VAC Power Questions Stanwax

[eighty8]

I have decided to take the advise of many and replace my Phenix Technology board with a Stanwax ILDA Board. I am a little worried with the load on the 24v 1A Power Supply may be pushing it.
Currently it has the Scanners, Scanner Amps, a 12v Fan that is .16A, and I'm planning to run the Stanwax from a 15v output from one of the Scanner Amp Boards

Is this something I should worry about or does it seem to be OK? Can anyone recommend a better Power Supply for this?

Below I have pics of my Scanners, the Phenix board, and the Stanwax board.

Thanks
-eighty8

[michelrietveld]

Hi, i also run the stanwax board power from one of the DT drivers, only drawback is that the power supply for the scanners/ilda board stays on when the kill-switch is pressed to shut of the laser diode power supplies so in case of a galvo issue the power stays on but at least the lasers shut off.

Michel