HI!
These are reworked too, we have a smaller version of them , yes. And the bigger ones with DCDC and a lot of features...
BR,
Phillip
HI!
These are reworked too, we have a smaller version of them , yes. And the bigger ones with DCDC and a lot of features...
BR,
Phillip
Hi Phritzler. Can you post a picture of the drivers? Also, how much is shipping to the U.S.?
Warm Regards,
-David
"Help, help, I'm being repressed!"
Yes I could use a handful
Hello!
We have more versions of the drivers.
This is a simple 3ch driver without any big extra features.
Only 200kHz analogue modulation 4,5-25V working voltage, 0-3A , threshold and standby beam supression.
Each channel has his own powerinput and modulation input. Itīs a highside driver - so the diode case can be on gnd.
There is a DCDC board avaiable with 3 dcdc converters for each channel if needed. And external tec drivers for sure .
This is the more simple version, working well and is for sure enougth for the showbusiness
Pic :
Our other drivers, which get reworked now are the colordrive :
Fullbridge tec, 1/2/3ch, each with DCDC, Overheat/undercool protection, differential input, adjustable beam surpression, 5A, 1,3Mhz analogue modulation (!), interlocksystem, etc.pp
Pic of the 1ch Colordrive PROTOTYPE:
BR,
Phillip
Last edited by Phritzler; 09-13-2017 at 00:49.
Mine is much simple. 1CH with size of ~31x37mm . High side with SBS ; power on delay and literally no power on lethal voltage spikes like BBe's older boards.
I have few pieces only for my projectors .I can't make professional look PCB yet. If anyone asks i can mail the diagram.
I apoligise for the cell phone picture with lasor burnt pixels and unwashed flux on the board.