How to drive the NUBM07E LD
Hello All !!
.
I need to drive the NUBM07E to about 4.4 A and need analogue modulation to control the output
I wanted to use the H2S dual driver from LSP. Dave noted that the drivers should not connected in series.
Before my email exchange with Dave...I was assuming that I would use a series connection arrangement....with each of the two drivers on the H2S unit providing 2.2A a piece.
.
But...he sez no ! OK...Anyone else out there using the H2S to drive the NUBM07E ?? In some fashion. did you connect both drivers on the board ? How ?? In a parallel arrangement ??...using balance resistors ???
.
Finally....What other driver has anyone used to power up the NUBM07E. This LD is current hungry and I want to supply 4.4 A @ 5.0 VDC as a maximum.
.
Any suggestion will be greatly appreciated !!!
.
Thank you,
CDBEAM
.
Note: Wow...Just checked Ebay...many new drivers out there...X-Wossee, Lasertrac, Optlasers and Ricktrent...Anyone have ANY comments on these units ?????????????? I have had experience with Opt Lasers and Lasertrac....they have great quality !
Last edited by CDBEAM; 12-17-2016 at 06:33.
Reason: Added Ebay note
Beam Axiom #1 ~The Quantum well is DEEP ! Photons for ALL !!
.
Beam Axiom #2 ~Yes...As a matter of fact...I DO wear tinfoil on my head !!
.
Beam Axiom #3 ~Whe'n dout...Po ah Donk awn et !!
.
Beam Axiom #4 ~A Chicken in every Pot, and a Laser Lumia in every Livingroom !!
.
Beam Axiom #5 ~"Abstract Photonic Expressionism"....is "Abstractonimical" !!
.
Beam Axiom #6 ~ "A Posse ad Essea" ~ From being possible to being actual ...is the beam target !