Delta ilda board oem-e-v1

[deltalaser]

Hello to all , i want to share our design ILDA laser board if you want to build your own laser projector with high-quality design and all ilda standarts. We have a solution for you.

1. Specifications

Compliant with the ILDA ISP99 standard specification.
4 color channels with analog modulation support: Intensity, Red, Green and Blue.
X and Y scanner control with connectors for X- and Y- inversion.
ESD protection on all ILDA inputs processed by the board.
Opto-isolated Interlock and Shutter support.
Three connectors for opto-isolated laser activation protection, e.g. for key lock, emergency stop button, etc.
Isolated interlock and activation protection output for daisy-chaining of multiple lasers.
Laser start delay, settable from 0 to 60 sec.
Optional laser manual reset connector (protection against accidental laser activation in case of a power outage).
Two sets of connectors for each color channel and each scanner dimension.
Input and output ILDA connectors (respectively male and female DB25).
Connector for optional MCU control.

Power supply: dual power supply with -15V DC, GND and +15V DC connections.
Fuses (1.5A-2A), reverse polarity protection, over-voltage protection.

2. Terminal Connectors

3. Full Datasheet Link Here
Official Web Link Here

[JohnYayas]

Tell me more about it.

[Laserpower]

Looks nice. But a shame you didn't add 2 voltage regulators (7815 &7915) for the +/- supply. So it could handle +/-24 volt power input is more universal. :-)

[kecked]

I think stanwax board with dz correction does 24v

[deltalaser]

Hello i see , we think about this problem and it will be dealt with in the next version. Some people want +/- 15 some want 24V. We will make second version delta ilda oem-e-v2 with +/- 24V. Some scanner sets on their board have out +/- 15V.