Results 1 to 2 of 2

Thread: interface issue

  1. #1
    Join Date
    Oct 2017
    Posts
    2

    Laser Warning interface issue

    Dear members
    I have a question, a month ago i bought a old laser. and it came with an interface.
    the easylase 1 and with phoenix software.
    there are 3 dmx ports on it, and a db25 port.
    I have installed the drivers etc.


    My question is can i run this in ilda mode without the use of the dmx port's?


    or does it only work with the dmx ports ?

    when i load Phoenix i can play ilda files but the galvo's aren't moving at al, the same in he laserscan.
    both programs are recognizing the interface but somehow i don't get an output signal to the laser.

    hope you can help me out.
    With friendly regards Remco
    Last edited by oxygen; 10-07-2017 at 07:32.

  2. #2
    Join Date
    Oct 2017
    Location
    Northants U.K.
    Posts
    12

    Default

    On my cheapo Chinese laser I plug the ILDA cable into the db25 port, it then plays the ILDA files. What DAC are you using? sounds like it might be an issue with the DAC?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •