Alright well I continue to code ma lazerrrr...
I thought maybe I needed a Sleep() after the CloseDevice(dac) and Close() to give it time to tell the DAC to shut down nice n clean.
I put in the Sleep()s and that seemed to help, but still there's a problem during shutdown.
I also noticed the LEDs on the ILDA cable side of it were both dark
That doesn't sound good.
So I gave Jacob(j4cbo) my repro code stripped down and the log file I found that the .DLL creates.
I also noticed that the name (ip address in hex) of the DAC has extra f digits in it
This does not seem like super dead accurate reliable firmware to meee...
But I did make progress drawing a blue rectangle starting small in the center and expanding to the full square.
I can dig THAT. Had to drop to 1000 pps to give the scanner time to get there without any pixel tuning.
Hopefully tomorrow I can tune color and make a device list config where i give the name to make SURE
I've got the right DAC, configure color tuning, optionally flip x and y coords, limit the coord system, etc.
Progress is slow. But, eh, that's ok. It's fun
...Steve