The LENS27 beam diameter @ 24m is <20 x 15mm with this .65um DVD diode, so far field will be a close match to most greens and near field 4 beams in a <3.5mm area should be possible
The LENS27 beam diameter @ 24m is <20 x 15mm with this .65um DVD diode, so far field will be a close match to most greens and near field 4 beams in a <3.5mm area should be possible
Thanks Simon. Well, LENS-27 just ordered
It would be pity to have such a nice module, with bad optics
Hi SBK,
I am in the proces of milling my own mounts and I was wondering if you could share your building-plans of your mounts? If you wish to keep them for yourself I understand .
,Jordy
Life is short.... Ride it hard!!
Little update : I received the LENS-27, installed them, passed a lot of hours trying to get the best alignment of the 4 beams, and now I finally obtained a relatively good beam data : total is 2x4mm, but the most power concentration should be on an even smaller surface
Also I developped a small TEC driver, it's the lil board on the top of the module. It's adjusted for 20°C +-1°C, and seems to works well, despite it's only an on/off circuit with constant current source.
And maybe I should consider an external driver case, as all these boards take a lot of place...
Ah and about the power, I obtain a nice 1.2 watt after all the optics, with 350mA per diode, I'm quite happy
all i can say is...freaking wow! when I grow up I want to build something just like that! Do you have a laser engraver also? appears to be about 5" x 5" again I say...WOW!
Pat B
laserman532 on ebay
Been there, done that, got the t-shirt & selling it in a garage sale.
Thanks That comment makes me forget a little the freakin hours and problems spent to build this module I didn't count how many times I told me if only I simply buyed an already made laser... But now I can say : I did it myself
Yes at my work I have some 5W laser engravers which I can sometimes use for my own purposes, it's nice!
In fact the size of the module is 88 x 72mm (3.5" x 3"). But it's quite large compared to the modules of p1t8ull or MechEng3 lol.
damn...and .....wow...
Pat B
laserman532 on ebay
Been there, done that, got the t-shirt & selling it in a garage sale.
Great job SBK! those LENS27's are expensive but give excellent results
When is the first production batch run of these modules starting?
Yes, expensive, about 40$ per unit, with the customs tax!!
Lol, I think I'll never again build a red module, that's too much work Although, now that I know better how to proceed, it would be easier to make one... And will certainly change some little things in the design, especially on the adjustments side