Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums Groups Groups
Filter by: Forums Last 7 Days Clear All
  • LambdaPhysics's Avatar
    02-13-2026, 14:29
    Hi, Following the completion of a recent project, we have a limited stock of optical mirrors for femtosecond Ti:Sapphire lasers available for sale. The mirrors are available in diameters of 25, 60, 80, 120, and 155 mm, with prices ranging from EUR 35 to EUR 2,000, depending on diameter and...
    0 replies | 194 view(s)
  • swamidog's Avatar
    02-13-2026, 11:58
    not legal. the seller is confusing (perhaps intentionally) the fact that the projector also needs to be varianced. regardless of living room or public performance.
    3 replies | 4371 view(s)
  • Greg's Avatar
    02-12-2026, 23:07
    Greg replied to a thread CYGN-B in The Lounge
    I will again when testing the new build, but yes, 5V per div on the scope shows clean flat +-15 and +5. The new one shown here is almost ready for testing anyway.
    1031 replies | 5564762 view(s)
  • masterpj's Avatar
    02-12-2026, 08:43
    no it not legal. I also question the products longevity lacking tons of cooling.. scanning likely going to be crap at the low currents/voltages.
    3 replies | 4371 view(s)
  • laserist's Avatar
    02-12-2026, 08:10
    laserist replied to a thread CYGN-B in The Lounge
    Have you checked your supply voltages?
    1031 replies | 5564762 view(s)
  • PhantomRage's Avatar
    02-11-2026, 13:47
    any luck on finding the paperwork?
    2 replies | 2282 view(s)
  • NobleGas's Avatar
    02-10-2026, 23:46
    Thanks Steve; I have located a suitable crystal that is damaged, but has plenty of undamaged material to be able to cut 1, or possibly 2, crystals. Now all I have to do is locate a local person who has lapidary skills! I found a club, but it's at the opposite end of the country from me.
    2 replies | 886 view(s)
  • Greg's Avatar
    02-10-2026, 20:20
    Greg replied to a thread CYGN-B in The Lounge
    I've replaced all the semiconductors including the transistor and the diode, and the problem persists. The only thing that seems possible is a breadboard connection failure that survives spraying and re-seating, as unlikely as that seems. so I'll be converting the parts seen in the tray into a...
    1031 replies | 5564762 view(s)
  • laserist's Avatar
    02-10-2026, 05:20
    laserist replied to a thread CYGN-B in The Lounge
    A4?…....................
    1031 replies | 5564762 view(s)
  • Greg's Avatar
    02-09-2026, 06:54
    Greg replied to a thread CYGN-B in The Lounge
    Progress has been delayed by a problem that has appeared in the previously working SPGN circuit. I can't figure out why the "spiral out rate" control voltage input no longer has an effect on the fall time of the ramp signal that it is supposed to control. The "spiral in rate" and the fine adjust...
    1031 replies | 5564762 view(s)
No More Results