Anyone know of a way to fine tune colours with an fb3 ? Can't find much in livepro or quickshow aside from the three colour sliders in projector settings.
Lasers are ~500mw of 532, ~400mw of 640 and ~270mw of 473
Right now I have a 3 channel fb3, however I'm unable to turn up the green past 50 - 60% without saturating both the red and the blue (the blue to a greater degree I think though)
I'm debating whether to look at adding some 445nm to my existing 270mw of 473nm, or trying to ebay it at a bit of a loss (It's about a month old, only 5 hours or so on it as I'm still finishing the case). But could put the money towards some 445nm and perhaps more red.
Since I'm using a 3 channel fb3 I'd be stuck with sharing the blue modulation line for now, however would be looking for a second dac anyhow soon and was thinking a six channel fb3.
Also, I cannot find anywhere in any of the included software where one can fine tune the colour palette. Is this a feature of the ld/qm2000 only ? Anyone know if this can currently be done or if this is a feature planned to be added to the software soon perhaps ? I'd think that would be a useful feature expecially with more than three colour channels, so hopefully it's in the works.
Unfortunately though an ld/qm2000 is just out of my budget for awhile I think I'd have to get that version of livepro as well, etc.
Appreciate any advice
Cheers