Results 1 to 5 of 5

Thread: Scanner Upgrade, Problem connecting

  1. #1
    Join Date
    Aug 2008
    Location
    around the Baltic Sea
    Posts
    164

    Post Scanner Upgrade, Problem connecting

    Hallo!
    I have a RGB laser and want upgrade the scanner.
    New scanner called "CT 6210" + driver Apollo micro amp.
    Connection, in principle, I understand, with connecting power supply problems are not.
    The problem in the connecting of operation's is as follows:
    in my RGB laser old scanner (or rather their drivers) connected to the ILDA control board through a 3 wire connector (three pins), and my new scanner and its driver connecting with ILDA control board via 4-wire (X +, - and And +,-).
    What should I do? Can I install both a new Included Parts scanners?
    Attached Thumbnails Attached Thumbnails IMG_0248.jpg  


  2. #2
    Join Date
    Sep 2006
    Location
    Netherlands
    Posts
    1,435

    Default

    The real question is : do you want to keep the ilda control-board ?
    I think it's hard to ditch it completely because it probably contains the diode divers and some interlockfeatures too.

    If you don't use dmx control or super-auto-magic:
    Look up the contacts of the db25 and connect the drivers to the proper ilda pins:
    +X - pin 1
    -X - pin 14
    +Y - pin 2
    -Y - pin 15


    If you do use dmx control or super-auto-magic:
    Connect the drivers to the control-board
    +X - to Xout
    -X - to gnd
    +Y -to Yout
    -Y - to gnd


    That is, if I understood your story correctly

  3. #3
    Join Date
    Aug 2008
    Location
    around the Baltic Sea
    Posts
    164

    Default

    Thank you for your reply.
    Apparently, I'm not quite understand you.
    Do you want me to chose the DMC or ILDA?

    In the figure this board have DMX and have ILDA.
    I want keep ILDA board.

    The main question: Can I connect the apollo micro amp driver with 4 pins on the scheme as you have written to me, that is grounded "X -, Y- and +X - to Xout, Y -to Yout ?

  4. #4
    Join Date
    Sep 2006
    Location
    Netherlands
    Posts
    1,435

    Default

    Connect the drivers to the control-board

    +X to the X output of the ildaboard
    -X
    to the gnd of the ildaboard
    +Y to the Y output of the ildaboard
    -Y to the gnd of the ildaboard

    surely you must find out first what the 3 pins on the board are x, y and gnd.

  5. #5
    Join Date
    Aug 2008
    Location
    around the Baltic Sea
    Posts
    164

    Default

    Ok thanks for the reply
    I just wanted to clarify:
    that the 6210 scanner which I set before standing in my other projector, and were connected to the other ilda board with a 4 pin connector, ie, X, X +, I-and H +.
    But now, in the projector where I want to install the scanner on board ilda 3 pin connector.
    and I doubt whether string any of these fees correctly and without consequences.

    but now when you explained to me I am calm and I'm glad that they can be correctly connected to each other.
    Thanks again for your help.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •