Hi all,
I ended up getting one of these 445nm 500mW lasers from Laserwave when I ordered my 637nm 500mW
http://www.laser-wave.com/en/2010/1028/article_72.html
http://www.laser-wave.com/en/2009/0121/article_38.html
Has anyone used these all in one drivers before? I am assuming the diode in the head is rated for 1W like the C@sio diodes. How would I go about adjusting the driver current? or would it be more involved than that?
There just isn't enough blue for my 500mW 532nm and 500mW 637nm.
On a side note I think the red is slightly out of alignment as I get a feint offset line when scanning. I have emailed Bridge so I hope I get a reply tomorrow.
Cheers
Rich