Ishow install help

[pyroibw]

Hi.

First off let me say im new to ILDA and this is my first time using laser software. i recently purchased a 1w RGB laser with ishow from a Chinese company I get my LED lighting from. the install disk they sent had nothing on it, so after searching for a while i was able to find a download link for the IShow disk. the program itself installed perfectly and runs fine, but i can not get the drivers to install. ive tried everything i can think of, so i wanted to see if anyone else had this issue.

[pyroibw]

well i think i figured it out. i downloaded an older version for IShow. Mine is 2.3. dose anyone have the drivers and or program for IShow 2.3?

[nickfontaine]

Hi pyroibw,

I think i bought the same RGB 1W Laser ILDA as you, with the ISHOW 2.3 sofware. From China !
I got a CD... but in very bad shape...

I have installed the sofware on a PC computer, running XP and also tried Windows 7 but without any results.

I followed the procedure... installed the USB drivers and then the software.
I have set the Laser Box on ILDA, turned the Key to the right, connected the computer to the Laser Box with the USB box and cable...

When i test the sofware on Play Mode, i see the animation preview on my laptop screen, but all i get on the Laser projection side, is a SINGLE POINT.
The colors are respected (when i switch colors) ... but no animation, no shape... just a big laser point in the center.

What did i do wrong ? Did you find any other Driver i could test ?

Thanks for your suggestions and help !

Cheers,
Nicolas