QuickShow Cue Isssues

[sirevrik]

Hi Folks,
I hope someone can give me some advise. I traced in an American Flag that resulted in 733 points, after cleaning. The problems is my FB3 is showing RED at 5 fps and it is flickering bad. Does anyone know why this may be occurring and or does anyone know where to get a nice American Flag cue. I looked at the one in LD2000 but the frame rate was pretty extensive and this spot in my show has another flag in it (thought that one is only 196 points) I tried the American flag completely alone, and it is still 5 fps and flickering.
Any help would be greatly appreciated.
Thanks

[White-Light]

I have the outline of America with a US flag within it. Does 22FPS if thats any good.

It's contained in the Quickshow Mini Pack - Landmarks and Famous People.

Register on www.pangolinshows.com with your FB3 serial

Then click this link: http://www.pangolinshows.com/showdetail_304.html

..and if you like the previews (it cycles through them) download the pack and you'll find it in there.

It's a genuine Pangolin website in case you're worried.

[sirevrik]

Thank You very much White-Light.
I just downloaded the pack and I will give it a try.

[White-Light]

No problem. It's not quite what you wanted but it may be close enough.

BTW you'll never get the full compliment of stars on the flag via laser as there are simply too many points / awkward corners. So if you do look for a flag in IDLA format, if you don't like that one in the pack, look for something simplified.

[sirevrik]

Hurray, no flicker. Thanks again White-Light. I needed to represent a union flag from the civil war clashing with a confederate flag. The part is very short so this will definitely do the job. Thanks again.