Hey guys....Im having a problem with 2 different lasers of mine...1 RGB and 1 Green only.... its kinda hard to explain but ill try.
this picture probably sums it up best..... This is a problem i have always had since i built these...
The lasers always start fine and look great but the problem arises if I leave QS on auto...or when i crank the animation speed up or scan more than 75% on x axis total size..... I can pretty much keep it under control as long as I don't scan to wide. I don't even know what to say about it other than it looks like all blanking disappears all of a sudden and the animation turns to mush.. It only ever happens on 1 of my RGBs..the other RGB has never messed up. They are both exactly the same in every way. and then on my last show my green only scanner started having the same problem....
Whenever it happens I have to go on stage and unplug the laser for 10 sec...I can then plug it back in and everything is fine(until it breaks again)
Have any of yall ever had this problem? What could possible be going on?
The scanner specs are..
1W Kvant 640
1.5W CNI green
1.3W Edison blue
DT-40
stanwax breakout/interlock
thanks,
-Brooks
KGBlasers.com