New mini RGB build

[badger1666]

Pm me your address and i will send you
Proper heat transfer sheet , and a couple of bolt isolaters ( like whats used on transistors)
So you can still use steel bolts, the nylon ones will just stretch and laser will move

Yeah, as well as Nylon M3 bolts i've just ordered some Kapton tape to insulate the barrel in the mount. Do you reckon 2 or three layers under the mount should insulate that too?

[RGbee]

Cheers buddy, PM coming

[andy_con]

yeah chris is right, ive done the whole nylon bolt thing and they are poo.

[badger1666]

The only driver onboard is the badpip quad. That's mounted directly to the base plate with 4 M3 cap screws through the FET's

Your safe with that
When you finish rebuild check continuity-on your green to base plate and any other dc ground to baseplate no bleep from your multimeter = good

[RGbee]

Just a quick update of the mini projector. Sides, top and bottom plates are now cut. I've made acrylic blanks for the front and back so i can corectly place the output window, IEC, keyswitch, fan and ILDA. Painting after

[tribble]

Just curious how this little bad boy turned out... killing time waiting for my parts by reading old build threads. This one's a beauty!

[hakzaw1]

I agree-- subbing

I am about to wire up a RGBV lumia kit- was planning to power all four 12vdc mini ttl labs together from one PS- will I be making a mistake??



TY hak

[RGbee]

Slight issue with now ex-adulterous wife since i started the build (not the projectors fault)
It's currently all in one piece, minus the casing, although i need to replace the cooked green (pointer cores = non existent duty cycle) with a 520.
also, scanners started screaming the last time i switched it on.
As soon as i've made more progress on it i'll stick up some more pics