Crap.... more money to spend

[Bradfo69]

Gee... thanks. $52 later....


ThruVue isn't probably going to be any better since it's 40 and 60 lpi.

[laserist]

http://www.edmundoptics.com/optics/o...-arrays/43-028

does about 14 degrees...(3 inches at 12 inches from the array)

Actually on this one you need biggish pieces and a large diameter bearing ie 25 mm or greater or a good quality Lazy Susan bearing.

Downside, we need to make a mold, its not a stock shower door material any more.

Steve

[Bradfo69]

Well, the ThruVue arrived and it appears useless in the first test. Now... that was just holding up in front of an RGB projector running patterns and looking at it on a wall about 100 feet away. It just stretched it into a huge muddled line. More to report after some more playing on Monday but, I'm not getting my hopes up. I'm a little discouraged that Greg says the lenstar kit was useless. I would think a higher lpi might yield better results.

Sigh...I think I've wasted $70 on getting these two sample packs. I should have just bought the damn Chauvet in the first place.