Proteus Flow Switch for Coherent Purelight

[danielbriggs]

Does does anyone have a new / good condition / tested working Proteus flow switch for a Coherent Innova Purelight for a good price?

The one I've got, while it has been repaired, has majorly cracked and has no pulse output... so needs replacing.
I don't know the exact model number required.

Thanks in advance!
Dan

[dsli_jon]

Does does anyone have a new / good condition / tested working Proteus flow switch for a Coherent Innova Purelight for a good price?

..You rang, Sir?

I'll test the 4-5 we've got, and let ya know, later on.. PM-ya a pic, I'm thinking 1/2 price should be comfy, ya?

cheers..
j

[danielbriggs]

Sweeeet! Cheers Jon.
I look forward to the PM .

[dsli_jon]

Good Sir Briggs -

I look forward to the PM...

Olritie, then - well the flavors of the hour are Vanilla or Caramel..

..ps - No-worries, I'll have those 'spade-lugs' back on the brassie, before shippin' nice an' snug..

... I'd suggest the 'Caramel' since a) it's 5 lbs of solid Brass badass Proteus-wheel... and b) it has a *replaceable* coil-element, unlike Mr Vanilla, who's coil is sadly potted.. (..plus the 'celcon' is more desireable to me, since I can also retro-fit those for KTP-repairs..

..the *only* concern, is that the only ones I have, that have the proper coil-Ω value for you, are 3/4" ID FIP, vs 1/2" ID FIP, like I *think* you may have in your pic...

..which-means, that you may have a bit of retrofittery to deal with, in either case, above.. And, as I know that 'space is already tight' in that chassis, it might be a good-bit of it... I'm sure you're 'well-up to the task'... just a fair 'heads-up', eh?

So, I'll PM you on the 'pence' side of things, in a few.. Lemme know yer thoughts, and we'll go from there...

cheers..
j

[danielbriggs]

PM-enroute!

[dilbert]

Dan, after you replace it remember you will need to remove the 'mod' I did to the drive for the interlock relay ;-)

[danielbriggs]

Sure do!
It was just that single wire link we made in the end?

[dilbert]

Yes, thats the one - was taking 0v gnd to the relay coil.

[rharperla]

I think that I have a couple. Let me know if yours tested out OK Jon. If not, I can hunt them down (in storage at my place in the desert). I could take to you after to test and sell.

BTW. Sorry I haven't picked up my UCGs. Ive been so busy. I'm actually working in Van Nuys in the AM tomorrow and possibly a few days following. Let me know if you will be around your shop. I could maybe pop in and say "Hi"

Robert

[danielbriggs]

Thanks very much for the offer Robert; Jon has sorted one out for me which should land in the UK in a week or two.
Best Regards,
Daniel