I'll take 3.
Awww Yissss.
I'll take 3.
Awww Yissss.
I'll take 6, please, if it is not too late.
Thanks...Mike
Runs with Lasers
Oops, please cancel my order; major brain fart there.
(Forgot the lasers I have already have drivers, heh, heh.)
Sorry about that.
...Mike
Runs with Lasers
I'm in for 3, depending on delivery date.
~j
leading in trailing technology
The GB is continuing. I'm ordering enough to supply the private orders as well as the public ones here. Thank you all for your participation.
By the way, I thought you would find this scope shot interesting. I've set up a test rig to replicate a challenging situation: when the driver has to drive an inductive-nonlinear load. Here is the P3 operating at high frequency with a somewhat inductive load, created by tightly twisting and coiling lead wires. The top traces are the voltage measured on each side of a 1/2 Ohm resistor going to a diode load. At first glance it appears there is current overshoot, but another look is required to get the full story. Oscilloscopes only plot voltage traces, and wires, etc have some inductance, so how can just the current through the diode be plotted? The answer is to perform a differential measurement across a sense resistor.
The bottom trace is the actual current going to the load, calculated by subtracting the traces from each side of the current sense resistor via the scope's 'math' function. As you can see, there is no current overshoot and the diode current glides carefully to the preset current as designed.
I'll keep you informed of updates are they are available!
Last edited by drlava; 05-13-2013 at 17:09.
I'm in for 6.
Thanks!
Hi all,
New to forum
I want to order 2 please. I'm in South-Africa though, will this be a problem ?
Also can anyone tell me when will these drivers be available?
Sorry I'm little desperate, need them for a project as soon as possible.
Thanks guys.
Great forum!!
Regards
I'm in for 3 - just want to make sure these are counted towards the total!
Greg
"Information not shared, is information lost forever"
Join ILDA
Support Photonlexicon
Put hakzaw1 down for two please=if you are bringing any to sell at SELEM I will be good for 2 or 3 more--if you want to hold the first two till SELEM that would save me a little on shipping- and I can pay for the first two now..THNX Andrew
Len
Hi, please cancel my order of 2 flexmods!
Sorry if this caused any inconvenience .
regards.