Cable Help. Medialas Micro Amp and CT6200 scanners

[Laserpower]

Hi Guys.

Do anyone of you have a wire schematic on a cable between a Medialas Microamps and a CT6200 galvo (beleave it's the same as the 6210 pins) :-)
Also if anyone have some X-Y block's and Mirrors for the 62xx galvos. please let me know :-)



Thanks.

Best regards
Poul.

[mixedgas]

See:

http://bit.ly/1aZXJrd

We have no way of knowing if Medialas used the standard pinouts. You will have to email them. Dirk does not reply that fast, he is usually out playing with his race cars. Have patience.

Amanda Pou at One Stop Laser Shop can sell you the blocks and mirrors.

www.onestoplasershop.com/

Steve

[Laserpower]

Hi Steve.

Thanks.

I just used 20 min in measure on the Medialas PCB. And have made a simple drawing. Are 99.9% sure about the Media laser Pin. Looks to be a 6800 1:1 pin. But don't know for sure if the wiring are correct. The AGC is a good qustion. Any comment are welcome :-)

Please attach Drawing. :-)

/Poul.

[mixedgas]

See Attached.
I'll have to scan in the factory cable drawing in the morning. AGC is just the current source for the LED in the position sensor. The LED current varies slightly as a function of scan angle in most amps, to aid in linearity correction. The LED current returns to AGC return, not system ground, in better amplifiers.

Steve