Senior Member
Flexmod p3 question? which pads disable the 7 second startup
From the instructions:
Disabling Soft Startup Safety Delay:
The 7 second startup delay can be disabled by
applying a solder bead jumper between the
rightmost pads of the 5-pad series at the
bottom left of the top side of the driver.
maybe I am having an off day and cannot find it. There is a chip with 5 pads but before I go jumping pins on a random processor or IC I wanna know if its right
Jr. Woodchuckington Janitor III, Esq.
did you look on the back?
Originally Posted by dream beamz
suppose you're thinkin' about a plate o' shrimp. Suddenly someone'll say, like, plate, or shrimp, or plate o' shrimp out of the blue, no explanation. No point in lookin' for one, either. It's all part of a cosmic unconciousness.
Senior Member
yes, but the directions specifically state the top
Jr. Woodchuckington Janitor III, Esq.
true.. it just wasn't clear if top meant top, or top meant front.
suppose you're thinkin' about a plate o' shrimp. Suddenly someone'll say, like, plate, or shrimp, or plate o' shrimp out of the blue, no explanation. No point in lookin' for one, either. It's all part of a cosmic unconciousness.
Senior Member
in the bottom it doesnt have anything in groups of 5.
If you look underneath the large resistor, there is a row of five pads on the top side of the pcb. Hard to see if the lighting isn't right, or if you're an old fart like me. Get a flashlight on it and you will see them.
Good Luck
"Information not shared, is information lost forever"
Join ILDA
Support Photonlexicon
Senior Member
Senior Member
thank you, i found it
perfectBridge these two.
Posting Permissions
Reply With Quote
Displaser
