-
Finishing line finally reached.
Goldenstar offered to fix the issues with the scanning and the board.
After using the laser I can see that the scan angle on the new scanners has been drastically reduced.
This sorts out the scanning issue. I wonder if the scanners were tuned to a much to high angle before. They did go pretty wide.
Makes the beams look stronger anyway.
And no problems with the board.
It cost me $160 to ship. Then $50 on the customs on their side and then another $40 my side.
But the laser was fucked so I'm grinning and bearing the cost.
I would still buy from these guys because they are reasonably cheap. I just hope the quality of my next laser is spot on.
Thanks GS for fixing!
Regards,
Graham
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules