Pangolin Quickshow - Beam Show question

[whiteg]

I have a pangolin QS question.
How can live show cue to cue brightness transitions in same time?
https://www.youtube.com/watch?v=1LbQCT9-OW8

The transitions menu no brightness functions.
How can I set the transition speed? (low speed transitions).

[norty303]

Why not start a new thread for your question rather than add it to every old thread about QS. Or if you're really struggling to get an answer, email Pangolin.

[whiteg]

I don't wanted each question to open a new thread.

Why not start a new thread for your question rather than add it to every old thread about QS. Or if you're really struggling to get an answer, email Pangolin.

[masterpj]

This line problem has been going on before.
*sorry didn't read the entire thread if someone mentioned it.
But this used to be a problem way back when I got my kvant 2.1 and I noticed this as well.

You will lose a little bit of brightness but its a workspace setting related issue.
You can do it manually but it requires you right click each cue and turn off some optimization settings.

There should already be a fixed workspace out for this.

I have exactly the same issues but, I don't believe Quickshow is entirely the cause. Yes, you can adjust some minor things via software but, I think it stems from a number of places - alignment, scanner tuning, beam characteristics, even the angle at which the projector is in relation to the output. So it's sometime hard to diagnose. I've sort of learned to live with, (and be frustrated by) it. Especially the dots.

It really is a cue setting related issue. Not tuning related
It can happen with both CTHP and LM scanners.


Edit: Uploading fix workspace now

[White-Light]

I have a pangolin QS question.
How can live show cue to cue brightness transitions in same time?
https://www.youtube.com/watch?v=1LbQCT9-OW8

The transitions menu no brightness functions.
How can I set the transition speed? (low speed transitions).

Transitions > Cross Fade

EDIT: Re Transition speed.

Correcting myself, you can control transition speed in the latest versions of QS.

Go to View in the top of the page menu and enable "Dynamics" from the drop down menu.

In the Live Control Area click on the Dynamics tab, then look at the bottom of that area. Below "Transitions" you'll find "Duration". Simply increase the value to slow the transition.

[whiteg]

Thank You for the help and informations

Transitions > Cross Fade

EDIT: Re Transition speed.

Correcting myself, you can control transition speed in the latest versions of QS.

Go to View in the top of the page menu and enable "Dynamics" from the drop down menu.

In the Live Control Area click on the Dynamics tab, then look at the bottom of that area. Below "Transitions" you'll find "Duration". Simply increase the value to slow the transition.

[masterpj]

I send a workspace to pangolin for evaluation on their request that should fix your problems
Hang in there if you are still having the lines on hot beams.