Another one 2W red module (4x 638nm mitsu)

[Bbe]

At last I has cracked the mystery of quad mitsu setup (and who killed Kennedy)

Of these days I finished my first multimode red quad setup. 2100mW@800mA/each diode. Better than 4x4mm beam at the aperture. TEC cooled at the 15° celsius. High-performance driver inside.

4xm3.jpg 4xm6.jpg 4xm5.jpg 4xm7.jpg 4xm1.jpg

Special thanks to Dave for his optics kit!

[The_Doctor]

(and who killed Kennedy)

That was Morbid Morley.

[kecked]

what driver is that?

[polishedball]

what driver is that?

His he has them listed here somewhere.

[dnar]

Drop the blue "laser like" killer LED. My pet leave, blue LEDs that kill your night vision....

[Bbe]

what driver is that?

This is my dual driver with a onboard tec and dc-dc

Drop the blue "laser like" killer LED. My pet leave, blue LEDs that kill your night vision....

My cat told me, it doesn't bother her. The main thing - the tail

[slogan]

Hello,
you put your correction optics after the cube?
correction before putting a cube, its quality is it better?

[swamidog]

nice! when do i get one?

At last I has cracked the mystery of quad mitsu setup (and who killed Kennedy)

Of these days I finished my first multimode red quad setup. 2100mW@800mA/each diode. Better than 4x4mm beam at the aperture. TEC cooled at the 15° celsius. High-performance driver inside.

4xm3.jpg 4xm6.jpg 4xm5.jpg 4xm7.jpg 4xm1.jpg

Special thanks to Dave for his optics kit!

[The_Doctor]

Hello,
you put your correction optics after the cube?
correction before putting a cube, its quality is it better?

If using cylinder lenses, I read that a few centimeters after the diode lens is best, so that path length might as well go through the cube. If one of the diodes gets a half-wave plate to rotate polarisation without rotating the beam profile, you only need one set of correction optics (cylinder lenses, or anamorphic prisms) after the cube. I doubt there's any significant gain is doing it differently, and you'll lose money trying.

[slogan]

If using cylinder lenses, I read that a few centimeters after the diode lens is best, so that path length might as well go through the cube. If one of the diodes gets a half-wave plate to rotate polarisation without rotating the beam profile, you only need one set of correction optics (cylinder lenses, or anamorphic prisms) after the cube. I doubt there's any significant gain is doing it differently, and you'll lose money trying.

ok,
thank you for the information,