Hello,
Is possible assign the same zone, like hot beams and two projectors?
Hello,
Is possible assign the same zone, like hot beams and two projectors?
If you want to use a single zone for 2 projectors then just connect both projectors to the same DAC.
If you want to send output from one zone to another, then you can use the 'Also to...' tab and you can easily copy/paste zone settings to make them the same shape, etc. Note that hot beam zones often have a setting applied to prevent re-routing of output. This is to stop you setting an 'Also to...' and enduing up with hot beams in an audience zone. but this can be disabled IF YOU ARE CERTAIN IT IS SAFE.
Frikkin Lasers
http://www.frikkinlasers.co.uk
You are using Bonetti's defense against me, ah?
I thought it fitting, considering the rocky terrain.
Also note if you are on 2.1, then you need advanced or ultimate for also to. This was a change from 2.0. To make hot beams safe you can go into the projection zone and hit the advanced tab and uncheck the box that prevents size and settings from effecting that zone. Then hot beams will only route in your "safe" areas.
Thank you!! !!!!!