Hi,
The glas is broken on our laser, modell Laserworld CS-2000 RGB.
I can't find the dimensions of the glas.
Also, is it possible to use plastic?
Regards
Mark
Hi,
The glas is broken on our laser, modell Laserworld CS-2000 RGB.
I can't find the dimensions of the glas.
Also, is it possible to use plastic?
Regards
Mark
Last edited by markin; 11-29-2018 at 03:18.
I haven't the laser in my hands atm. So I can't measure it myself.
Hoping someone can help me get the dimensions of the glas window.
Pretty sure the aperture on those projectors is ~ 2 inches square. Since the aperture glass attaches to the inside of the front panel, there's no harm in going with a larger piece (within reason). I would think you'd be safe with a 2.5 inch square piece. Just glue it in place with some 2-part epoxy and you'll be fine.
You can use plastic, but I wouldn't recommend it. Anti-reflection coated glass is what you want. Edmunds Optics sells it in various sizes.
Adam
you need to use AR glass.. Have a lookie here: https://shop.stanwaxlaser.co.uk/ar-w...-x-3-586-p.asp
another place would be edmund optics .. it all depends on where you are located.
Make sure it matches your apperature hole dimensions.. larger is fine as and you can always score cut it.. just use epoxy to glue it on the inside.. good luck!
I totally forgot about Stanwax's shop! His prices on Anti-reflection glass are *way* better than what you'll find on Edmund Optics' site.
Adam