Hello all,
I have two self-builds planned that need housings. I figure I would check on here to see if anyone has parts kicking around before turning to China.
I care a lot about aesthetics. My target is something like the goldenstar cases where there is fan cooled baseplate (forced air underneath.) Full good yoke, very square or rectangular and looks good.
One projector case needs to be small, I plan to mostly go single mode diodes using existing red SM, blue MM and pick up a green. Kind of an authoring projector. I have 30kpps galvos. This does not need cooled baseplate.
Second projector case needs to be larger, maybe 10" square on the plate. Forced air since I'm using laserwave 2 watt dpss and PT-40W.