more info
https://www.google.com/search?sxsrf=...4dUDCAw&uact=5
Our great friend Fred owns Surplus Shed . (in Pa)
https://www.surplusshed.com/search.p...surface+mirror
https://www.surplusshed.com/category/Mirrors.
I got some square FSMs there made by Kodak. nice size and larger enough to cut smaller, if wanted.
The cost was reasonable . ATM these are not offered.
The prob with 'regular or rear surface mirrors is the second and much dimmer 'other' reflection made by the glass. First or front surface mirrors make only one reflection.
HOWEVER the 'backing' of ordinary mirrors can be removed to reveal the surface and thus making it into a FSM.
I use paint remover. and go slow and carefully. An old and soft toothbrush worked well for me. Some mirrors are better for this than others. You need to stop once the surface is revealed. Some mirrors and paint removers work better than others.
Plain glass makes a 'mirror' that passes almost all and reflects very little AND there also exists double sided mirrors-- both sides are the same. These are sometimes found on spinning scanners.
'Dichros' are also mirrors that pass different wavelengths and reflect others and allow us to combine to make other combos of wavelengths. The 'other' way is knife-edging which puts the lasers very close together but not quite perfectly.
Two sources of FSMs are found inside old Polaroid cheapie cameras (like ONE-Step) -these are a good size as-is and are 'tombstone' shaped but can be cut IF great care is used--- the glass is very thin. I never pay more than 1$ for these at yard sales and thrift shops etc..... as the 'film' is hard to find ATM. There is also a very nice DC motor inside --great for laser spirograph etc.
Plastic gears are nice for mounting the mirrors to any motor. One that is a 'tight' fit make a mirror that makes almost a dot or very small circle-- to make a laser circle I use a gear that can be intentionally off- center. If not correctly set up the last mirror might be too small and some of the circle or reflection will be clipped, (not desirable)
Another source is the HUGE FSM found inside Rear Projected TVs (pretty much no longer being made AND in some the 'mirror' is plastic, I see these big TVs put out for trash all the time-- saw one yesterday BTW.
DO BE VERY CAREFUL when setting up bounce mirrors-- for sure something to be done while wearing eye protection, BTW these is not easy to set up w/o some help.
The best FSMs to be used as a laser bounce mirrors are usually close or larger than 6x6 inches which makes for easier set-up. These have two or more adjustments 'places' used for the final fine-turning. I have made my own from two or 3 pieces of Ally plate and some springs and thumb screws
Another FSM source is found inside flat bed scanners, often long and not very wide--some however are about 3/4 inch wide. These are easy to cut and vary in thickness.
High quality bounce mirrors from Edmond or Thorlabs are VERY spendy.
BTW
I have a large mirror over my bed.
Printed on one corner is:
'Objects in mirror are smaller than they appear' JK lol
Last edited by hakzaw1; 04-11-2020 at 17:49.
BEYOND-FB3/APC40Mamba Black(clone & currently on loan) 2X 5paghetti & 2 I-Show 2X KGB 1000mW 532 DT40K (pair)XFX 1300 RGB full color RGB 30K DIY 3.5WRGB work in progress et al..assorted ttl chi-jectors--LOTS of LUMIA DIY pjs-
Powered by Pangolin
Former (2.5 yrs) ILDA Member- :-(
uncertified ILDA LSO -- dont ask