Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: microcontroller programming

  1. #11
    Join Date
    Nov 2017
    Location
    iran
    Posts
    19

    Laser Warning

    Quote Originally Posted by cfavreau View Post
    You can probably pull the reset pin low... short it to Ground. Pin 7 is labeled NRST. Which usually is a pull it low to reset input. It is hooked up to an RC delay that holds it low until the power is stable. To double check put a multimeter on the VIA connected to the 10k resistor in the picture connected to the reset trace. To reset connect the trace to ground. You can connect a momentary switch ground and output to the reset trace.

    Attachment 58551

    please explain more about that , i do that and nothing happened. Can I have a WhatsApp number?

  2. #12
    Join Date
    Nov 2017
    Location
    iran
    Posts
    19

    Laser Warning gd32f103rct6

    hi , please guide me i find this link and i want program my ic ,wich file is program for my laser ic ? https://github.com/maximus64/sd_rgb500_cfw

  3. #13
    Join Date
    Nov 2017
    Location
    iran
    Posts
    19

    Default

    Quote Originally Posted by cfavreau View Post
    You can probably pull the reset pin low... short it to Ground. Pin 7 is labeled NRST. Which usually is a pull it low to reset input. It is hooked up to an RC delay that holds it low until the power is stable. To double check put a multimeter on the VIA connected to the 10k resistor in the picture connected to the reset trace. To reset connect the trace to ground. You can connect a momentary switch ground and output to the reset trace.

    Attachment 58551


    hi , please guide me i find this link and i want program my ic ,wich file is program for my laser ic ? https://github.com/maximus64/sd_rgb500_cfw

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •