I managed to save the Datronik club projector. I'm looking for glass like in the photo, it's a beautiful effect. I don't want to take it off the projector and put it on another projector. Does anyone know about this glass, where I could get it.
I managed to save the Datronik club projector. I'm looking for glass like in the photo, it's a beautiful effect. I don't want to take it off the projector and put it on another projector. Does anyone know about this glass, where I could get it.
Link to the video. Datronik projector Stuttgart.https://youtu.be/FyZS9Ry8qkM
I finished the Poly-10 sector today. The gears made a terrible noise and vibration. The device was too massive for my taste. Nema 16 stepper motors. The decision was clear to make a bar on which two micro stepper motors plus a simple speed controller will be placed. The result before and now.
I had a gm20 dmx controller made to order.https://youtu.be/XpNFZaeZKsk
Last edited by marusko1; 10-20-2022 at 05:33.
Today I installed new DC-12V motors and PWM controller. I got extremely low rpm.
Last edited by marusko1; 02-01-2023 at 09:14.
Yup, that’s what I use.
Good job…Mike
Runs with Lasers
What RPM are you using? I’ve had good results with both 2 RPM (variable), as well as .5 RPM (fixed) DC gear motors.
Displaser
"Information not shared, is information lost forever"
Join ILDA
Support Photonlexicon
I measured using the rpm application. As I expected, my estimate was correct. 0.3rpm I achieved super.