Hello I have recently purchased a Laser device that supports ILDA and tried to make the show, I connected it to Helios DAC With the use of Modulaser I wanted to check If they are compatible.
it worked fine for like 2 minutes but It suddenly made high frequency humming noise and with continuous clicking noise and also blanketing was occurring with the frequency of 0.5sec
( it made the projection to appear like 0.2s and then It was blanketed )
then I switched to the factory animation. In order to see If the device is damaged.
it was still intact, then I left the laser on to the ILDA again. while it is still making the clicking noise I try to eliminate it with software procedural. and then the scanner stopped as I assume with the projection didn't appear
I already kind of ditched the dream that repairing it from the manufacture as
I was in very loose transaction that warranty means nothing and
anyways The Chinese factory is going to blame me 'not using the FB3' (while I think that is total nonsense)
they did plenty of meaningless after service with telling me to open the device and take photo of inside if the cable is loosen
but I assumed and insisted from the very beginning that issue would be a motor itself
as I open it and run the device I found mirrors are Completely stopped.
so here are the things That I would like to know :
if this kind of happening is common?
is it normal that Inappropriate software setting damaging the laser?
and if that Laser Can Be sensitive to It's source device as the claim to be?
and what experts would assume the problem?
and more over if they are somewhat self repairable or replaceable?
Thank you
The Laser device is poor imitation of The Lasercube (only the shape)
I didn't care much as I was about to Use ILDA anyways in order to do what I'm planning