The dream beamz 1.7watt RGB beast is back :)

[allthatwhichis]

I spent quite a good deal of time tuning these; they're tighter than 10 virgins now!

Adam

Hey... That's not fair. I guess I'll have to take the g120s to someone local to get them tuned.

[buffo]

Damn - Bill Benner wrote the book on those galvos. (The G120's) If he can't tune them, no one can. (Too bad you couldn't score a set of the turbotrack amps he designed for them. That would really rock!) But the G120's are damn fine units, and I know Bill will get you running right.

Adam

[allthatwhichis]

Your item was processed and left our ORLANDO, FL 32862 facility on October 24, 2007. Information, if available, is updated every evening. Please check again later.

[buffo]

Enroute to Tavares, no doubt. You'll have them tomorrow.

Adam

[dream beamz]

nice, glad to see this priority mail package actually offered some tracking

the nice thing about the gsi galvos your getting is that these are gsi amps. most of the sets I had involved laser artistry amps that didnt do too well

[allthatwhichis]

Yea... but you have my power supply. I am going to use the PSU from the 30ks... I just realized that. Although the minisax pdf says +/- 15 to 24 volt. My fan psu is =/- 15 to 18 I think. It looks a lot like the one in the picture above that is for the scanners, right next to the green's driver in the top right.

[buffo]

I'll get the PSU in the mail back to you (along with the 30K units) as soon as I finish the review.

Adam

[allthatwhichis]

I'll get the PSU in the mail back to you (along with the 30K units) as soon as I finish the review.

Adam

That's cool man. I had a BIG grin on my face when I checked the tracking. Then I remembered about the PSU. And the grin disappeared. I think the PSU I use for the fans will work.

[buffo]

So long as they're dual polarity and can deliver at least a couple amps, yeah. I wouldn't bother wasting Bill's time tuning them though, until you get the correct PSU. (Unless you are SURE that your PSU can deliver both + and - voltage at the correct level, and with enough current, that is.)

The PSU's I used at FLEM were +/- 24 volts at 5.2 amps. They could in theory drive two sets of scanners!

Adam

[mliptack]

Man I cant get over the size of that red beam... I cant wait to see pictures of it running with the 20k galvos. Your power meter has seen better days...