Hi Everyone,
I've read in a few places (If I understand correctly...) Shows should be run at 30K or 60K and not in between. ( I may be stating this incorrectly as beam shows can obviously be run slower to increase scan angle.) I have run shows "designed" for 30K playback at 40K and they obviously look better because the scan rate is faster and their is less flicker. Why would it be a bad decision for me to run at this speed if the galvos can handle it and the output looks good even though my galvos are tuned for 30K?
Why would I not want to tune my galvos at 40K with the ILDA test pattern if they can handle that speed without overheating or erratic behavior?
I'm sure theirs a good reason but I don't understand how this works. Must be some kind of points optimization for the speed??
Your comments are greatly appreciated.
Thanks!
Adam