ExideGlow's RGB Build.

[ExideGlow]

New Update

location of power supply and scanner amp



holes for the scanner amp



no nut in this project









side plate of aluminium

power intake

It was all for today
more coming tomorrow

[liteglow]

nice !!

Just one little tip from me, it`s smart to have the amps pointing with the POTs out..
That way you can tune them more easy without removing them form baseplate

Second though , how do you manage to mount everything now when you did mount both the TOP plate and the bottom ?

It must have been better to first mount the lasers and power supply's ?


Anyway, this is looking goood !!!
Home tomorrow ? .. think I need to take a closer look

[ExideGlow]

nice !!

Just one little tip from me, it`s smart to have the amps pointing with the POTs out..
That way you can tune them more easy without removing them form baseplate

Second though , how do you manage to mount everything now when you did mount both the TOP plate and the bottom ?

It must have been better to first mount the lasers and power supply's ?


Anyway, this is looking goood !!!
Home tomorrow ? .. think I need to take a closer look

thanks Liteglow.

it is easy to remove a card if it needs to be adjusted

have measured up everything so I know where everything shoud be placed.

you can come tomorrow. if you want to see closer on the project

[Steve Milani]

Solid!
What will be final dimensions of the case?
You will use same thickness (5mm) for optics board too?

Steve

[ExideGlow]

Solid!
What will be final dimensions of the case?
You will use same thickness (5mm) for optics board too?

Steve

58 x 38 and top will be 25 cm.

yes 5mm alu for optics board. and angles to make it more stiff

[DZ]

hey Exideglow, the projector is looking good! I see you must have gotten the DT-40's with the larger mirrors since I see a notch filter on that board! What software/hardware do you plan on using?

[ExideGlow]

hey Exideglow, the projector is looking good! I see you must have gotten the DT-40's with the larger mirrors since I see a notch filter on that board! What software/hardware do you plan on using?

hey DZ. thanks.

i think i will buy Mamba black and Easylase Dac or fb3 with LivePRO.

I do not know yet.

what do you think about it ?

[DZ]

Ah, ok, was just curious. It looks great, keep up the good work and keep the pics coming! I like the rivet idea!

If the software you use has differential, you will want to use the 4 position cable for the input to the DT-40 amps. The ones you have connected in the photo with the pots are the single ended cable.

[ExideGlow]

now I am very little known at lasers so I welcome any to come with tips and advice

[ExideGlow]

Ah, ok, was just curious. It looks great, keep up the good work and keep the pics coming! I like the rivet idea!

If the software you use has differential, you will want to use the 4 position cable for the input to the DT-40 amps. The ones you have connected in the photo with the pots are the single ended cable.

yes i will come with more pics !.

hmm. what does it mean that I use single ended cable.
sorry for asking but I try to learn something new every day about lasers