LUMIA WHEEL making instructions for FREE

[LaserLover]

No not really, I used firefox the WHOLE time, no worries though I will fuse my own wheel just need to go get a new mold at bullseye and a clock motor! I have done more flamework and slumping than fusing but it should be a fun project (now too bad I can't get the glass cut with a CO2 laser).

-Adam

Hi Adam,
I've worked in Stained glass over 20 years.I don't have a kiln and can't justify the cost of ownership or operation. Fusing a variety of glass together could be tricky. Cooling has to be very controlled , otherwise the finished product could shatter. Good luck. I'd like to see a picture If you succeed.

Take Care
Rick

[sugeek]

Hi Adam,
I've worked in Stained glass over 20 years.I don't have a kiln and can't justify the cost of ownership or operation. Fusing a variety of glass together could be tricky. Cooling has to be very controlled , otherwise the finished product could shatter. Good luck. I'd like to see a picture If you succeed.

Take Care
Rick

You are correct, a microcontroller takes care of that, It will still be a pain in the rear and take two days to cool down... Makes beads look easy. I am sure that all of your stained glass experience helped make a wonderful guide, and thank you for making it available to the community. Your cuts looked very nice, I still am lacking in the glass cutting department (using somebody elses studio was nice), but eventually I should have a nice glass shop setup again!

-Adam

[LaserLover]

You are correct, a microcontroller takes care of that, It will still be a pain in the rear and take two days to cool down... Makes beads look easy. I am sure that all of your stained glass experience helped make a wonderful guide, and thank you for making it available to the community. Your cuts looked very nice, I still am lacking in the glass cutting department (using somebody elses studio was nice), but eventually I should have a nice glass shop setup again!

-Adam

Hi Adam,

Have you ever tried sandblasting glass ?
It produces some great optical effects and beautiful stained glass pieces, but kind of pricey to setup. One day, perhaps I can afford a kiln and sandblasting booth. Sigh !....

Rick

[LaserLover]

Hi Guys & Gals,

Thanks for all the folks who downloaded my free Laser Lumia instructions and purchased my E-Book.
Here's another freebie.
I just wanted to send you a quick note to advise you that I posted download links for MP3 sound files and a few ILDA frames of Homer Simpson.
They're available at " http://www.sniffinfo.com " for free download. More to come.

Enjoy
Rick@sniffinfo.com

[Docjohn]

Hi Rick:

Are you open to selling any of the wheels you make?

John

[LaserLover]

Hi John,

Yes , I can make you a custom Lumia wheel If you wish.
The cost of the 8 section Lumia wheel mounted on the 1 rpm motor (runs on 120 VAc @ 60 Hz) that you see in the web site promotion is $100 USD + S&I.
If you want something else send me a private message and we can discuss the details.

Thanks for asking.

Rick