analogue system running on TTL controller

[liteworx]

sorry if this a stupid question guys, just need reassuring on something...

If I run an Analogue Laser System from a PC Controller / DAC that only gives out TTL, Am I right in saying that the analouge diode will still be controllable
in that its either ON 100% or OFF 0% but no dimming in between.

I have an issue when running an analogue system from Zion Laser Software which I think is TTL output, and Im not getting any brightness out of my 532nm analogue diode, but if i run the system from Pangolin Quickshow i seem to get full brightness on the 532nm regardless if i switch the output from TTL or analogue on quickshow

Confused.com

Thanks for any help

i guess this is going to be a some kind of modulation issue ?

[ClearBlu]

Select the resolution for your output device, the lower the resolution the brighter the effects produced by your video projector. Check the set up under config.

[ClearBlu]

I'm sure there is analogue out as well as ttl
http://www.laserlightshow.co.uk/support.php#

[gottaluvlasers]

a TTL controller is perfectly fine in controlling analog systems. You should have no issues.

-Marc

[liteworx]

thanks marc thats exactly what i thought, dont know why i doubted myself.

clear blu....... resolution, video projector ?????????????????