This seems like the appropriate thread to find some answers. I have recently received an RGB projector built by Daedal (thanks man) The Red and green lasers I purchased are 300mW each. I am only able to get 100mW out of them before optics. I am using the DB25 breakout board, and an FB3 that has been modified to draw power from the USB. I have measured the voltage with a meter across the red and green lines while lasing as much as I can get them to and get a reading of 2.5 Volts. I am assuming that the lack of voltage is the problem but why is it happening? Could it be my FB3? Software? Breakoutboard?