High side driver

[edison]

He isn,t ready yet. I asked him today. he was out of stock! That supriseses me a little bit because its a good product. If i was him i would have at least 10 at stock. I prefer a board with 4 diodes and one tec that can deliver 3 amps for the tec. He said it would take two weeks to have new stock.

[lucerne]

Hi all

Sorry it took so much time to write here in the board. I just don't have the time to check all boards all days

Yes, they run out of stock, but I pushed my manufacturer a little. It seems they are also very busy, hope I get the drivers soon.
Believe me, this time, I ordered much more to have a stock of over 10
In future, I will always order some new ones, as soon the stock is below 10. I really didn't know about that kind of interest.

Other PicoDrive modules are coming soon!

Cheers, Leander

[lucerne]

Hi all

Me again. Finally, I had a chance to contact my manufacturer, it wasn't easy at this time. Without telling me, they were in holidays, that's because they have delay now. Just to inform you all. On 10th July 2010, they send me the assembled PCBs.

Cheers, Leander

[edison]

I would love to have a similar driver only with 2 outputs and 4 outputs both with a 2amp/5v tec supply on board that can power both blue and red diodes. I have developed a dual module that is being manufactured this week and i have a quad coming up within a few weeks. I,m still looking for a longterm supplier for good drivers The new kniveedging mount will be finished in a month. There is some delay because of the vacation in between. Understandable because everyone has a right to have some fun to load there battery