Fs: Laserman532 quad kit!

[ElektroFreak]

My red. 700mw....LOC's-Lava driver Tec cooled and yes- it cuts black tape. Low power...longer lifespan.

LOVE the anamorphic prism pair. Very nice indeed!

[Laserman532]

I have one quad kit still available on this run of parts, going to anodizer on Thursday, if you want this last one speak up for it...it will be sexy!

[dream beamz]

I have one quad kit still available on this run of parts, going to anodizer on Thursday, if you want this last one speak up for it...it will be sexy!

anyone claimed the last one? If not, I want it, full setup

I think I am going to do a quad BDR-203 setup after i give it a shot with some PHR-803T

[Laserman532]

WOW Thanks dream beamz!.. I will send you a PM with the details.

I will plan another run may be next week or after Christmas!

[hobbybob]

How much power could i expect when all aligned properly if i were to buy this kit, using the Long Open Can diodes i bought from Daedal ?
And what about beam profile ?
Is it possible to get it all aligned properly to a nice tight beam, or will it be very hard to do the far field alignment ?

Hope someone can give some info, i think the kit looks neat and well machined.
It could be the way to go to get a nice red in my projector.

[sbk]

How much power could i expect when all aligned properly if i were to buy this kit, using the Long Open Can diodes i bought from Daedal ?
And what about beam profile ?
Is it possible to get it all aligned properly to a nice tight beam, or will it be very hard to do the far field alignment ?

Hope someone can give some info, i think the kit looks neat and well machined.
It could be the way to go to get a nice red in my projector.

You can have 1.2W in a tight 2x3.5mm beam, with low enough divergence. But it will cost you some extra money for good quality lens (I have the Roithner Lens27), and cost you more than a lot of time to find the perfect alignement and make it stable

Note, this is when overdriving the LOC diodes (350mA), but they seems to support this quite well (though it is better to cool them with a dual TEC at that power level).

[mccarrot]

With the lenses I have a beam diameter of 2,5mm x 2,5mm with 0,6mRad is achievable with a quad setup

[edison]

Mccarrot you are to hounest

[badger1666]

please excuse my stupid question
but i am looking at the quad kit and working out the beam path but doesnt
one of the horizontal beams need to be higher for a skip over
how would i get around this , or have i got it all wrong in my head

[300EVIL]

please excuse my stupid question
but i am looking at the quad kit and working out the beam path but doesnt
one of the horizontal beams need to be higher for a skip over
how would i get around this , or have i got it all wrong in my head

No, the beam path would look something like this....