Need help installing PT-A40's into Laserworld Club Series
Hey guys,
I have a friend that bought a set of PT-A40 scanners to install in some old laserworld club series lasers.
We got everything mounted up but have an issue.
the ILDA board has 4 wires going into the XY+OUT and a pig tail that splits those 4 into sets of two. Those each went to X and Y on either side of the old scanner driver board (two wires each)
The new PT-A40's have individual driver boards for X and Y but the signal wire for these have 3 wires. The ilda board has 2...
Not sure what to do from here. Do I need a different ILDA board that has two separate 3 pin connectors for X and Y?
Please help!
Thanks guys
"This is not "work". It's a disease, addiction and passion. Only slightly cheaper than cocaine, but similar effects."
-dnar