Just a quick note to everyone that the FlexMod drivers from now on will come with LasOrb diode protection devices at no extra cost. While the LasOrbs are not in yet (probably 2-3 week lead time), I have updated the checkout page here. Currently you can select from the 'Red' LasOrb for 3V diodes and 'Blu-Ray' LasOrb for approx. 5V laser diodes.
If you order now, I'll ship your driver now and then when the LasOrb comes in, I'll ship that separately. If you need a combination of 'Red' and 'Blu-Ray' LasOrbs, place two orders (one with each selection) and the shipping of your second order will be discounted.
I have also updated the data sheet.
Specifications:
* Power input: 5-12VDC
* Analog Input: 0-12V max, usually you set to 5V full range
* TTL input: 0-5V Off-On
* Gain setting: 11 turn pot with 2 ranges 0-1A (Low), 0-6A (High) output.
* Bias setting: 11 turn pot range 0-2A output
* Dimensions: 31x21.5mm
* Input Impedance: 9.4k Ohms Low range, 1K Ohms High range
16 FlexMods on the board:
High speed linear modulation at 1A:
Very high speed TTL modulation with no overshoot:
Note: the FlexMod has nothing to do with, nor is sponsored by Pangolin the creators of the LasOrb. This is an independent sale.