FS: Cheap scanners and 532 TTL laser
Ok, I'm retrofitting one of my projectors with new scanners and laser so I have the old scanners and laser spare.
Scanners are (I believe) Scaneco 10's or 12's and have driver, psu and DMX board with all the fittings pre-wired. I modified this set with a opamp to reverse the direction for when used with my other projector which involved wiring in power takeoff and breaking into one of the wires where the op-amp went. Op amp not shown but you can see the power take-off where the bullet connectors are, and you can have the op-amp if you desire it!Otherwise complete with mic for sound activation and sensitivity knob.
Laser is of unknown descent, supposedly 100mW however it isn't as bright as my 'other' supposedly 100mW laser. Whether this one is down on power or the other one up (or a combination of both!) I don't know and I don't have access to a meter to test I'm afraid. It burns tape fairly easily but could be IR, again, no idea of power but the pics might give some of the more knowledgable people some idea. Shots taken with a little ciggy smoke in the room for effect!
No idea what they're worth, perhaps a little plaything for someone or 'My First Laser' project. Will separate scanners and laser, just looking for something to offset the cost of the new gear.
Reply With Quote
1.5W RGB internal FB3 scanpro 30's
