Activity Stream

Sorry, I don't know the Chameleon system, only the Verdi.

Thank you. Unfortunately, I am a novice. I did try the LBO temperature optimization through command prompt, but that did not help. Wanted to run FAP-I optimization but not sure how to access the diode optimization menu/service login on GUI. Also forgot to add in my earlier post, I am using this...

So actually yes, I solved my problem. It wasn't the diodes. My problem was that I played a bit (a dangerous thing to do) with the menus and EEPROM contents of the controller while in "maintenance" mode and must have wrecked something. In the end I went through the RESET procedure of the laser head,...

Pretty sure it was bad diode.

Trying to revive this again… did you sort this problem? I might have the same issue too, caused by a sudden shift in the wavelength. Thanks.

If the juke has unbalanced outputs - get unbalanced to balanced transformers...

The meeting with the program director at the city's second oldest operating cinema has occurred. I was told the owners are interested and a date might be in January. The plan is to have a table in the center back row and block off center parts of about four rows. The floor is on a shallow...

That board was just included for the parts. It had four fairly fast 12 bit adc & dac chips. It plugged into a IBM PC, and I used it to characterize the analog color computer of a Hell 340 rotary drum scanner recorder. I built it about 7 years after my time with Laser Images.

Here's a photo of the drum kit graphic recovered by lasermaster1977, shown in laser. Also shown are front and back photos of an interesting looking unidentified wire wrap board that came with the shipment that was picked up in Buffalo a few years ago.

These boxes were the only enclosures I could find that were big enough. I much would have preferred an aluminum extruded enclosure or an old show laser enclosure over a steel sheet metal one, but I made it work. I actually had to shave an inch of extra material off the optical table to make it fit!...

Thanks! I'm currently using LaserShowGen and a Helios Laser DAC. It would be cool to try an FB4 and QuickShow/Beyond, but that's a bit out of my price range currently haha.

Thanks! Believe it or not, it only costed me $250 in parts! I had access to a mill so the machining only cost me my time and $20 for aluminum stock.

Thanks for the info Steve. FIXED!