Hi, I just hooked up my Galvo's and amps and have a quick question.
I'm using the ScanPro 40 kits, they are the older style pictured here
http://www.lasershowparts.com/files/...ANPRO30_40.pdf
After hooking up the AC DC Converter, The voltage checks okay. When I pLug the power into the amps I get a red and green LED on constantly. I couldn't find any information on these LED's and what they indicate. I'm a little confused because the galvos seem to work, but red LED's usually indicate something bad.
I only have everything on a mock up card board setup so I can't run the amps for more than 20 seconds or so because they are not heatsinked. However they seem to be projecting the ILDA test frame okay through spaghetti. I can't really tell anything till i get my base-plate finished.
I just wanted to know if anyone knows what the red led indicates before I hook them back up.
Also, are they supposed to buzz quite a bit when in action?