output power difference between ilda and dmx

[oliverst14@hotmail.com]

if its analouge mate u can lower the output power when using with your rgb. this way gives u more versatility and allows for brighter green when needed. after all sometimes u might not use the rgb with the greens and then a brighter 1 green would be alot better.

[rgb-gas]

i have a few of the low power 330mw rgb they are ttl

[zpeakabonk]

tonight we do a test show in france for free and promotinal use

so i can see what this baby is capable to do

the 1w greens are analog too

i am thinking to take a bigger rgb later they give me an offer for a

1w red 635
1w green 532
500mw blue 473

wiht 40kpps analog i might take this one with the big greens


it depends of what we see tonight on the show it's the first time we take it in public

still whit crapy soft but pangolin is on the way(if i can find a good pango dealerbecause in france they ask 2300 dollars and that's a rip off 900 more than on the official pango site)

in a few weeks from now i will open the laser and shoot some pic's of his heart to see the build if it's quality or just some chinese crap

power is nothing whitout control ( i think i heard this one on tv one's)

bye michael

[mccarrot]

When I set my Qm.net at full power, and I connect my laser with a 5 meter ILDA cable, I measure 4.7V at the input of lasermodule.

So when using ILDA I have 0.3V loss on my cables, connectors, wiring etc. So there is a chanche it slightly less power compared to DMX. But in your case I would say its Ishow

[zpeakabonk]

wow i have just bought myself a 20 meter ilda cable

so i wont have any power left at the end



and yes i show is really really a shit program!



i must buy a bigger laser at the end

[Doc]

wow i have just bought myself a 20 meter ilda cable

so i wont have any power left at the end



and yes i show is really really a shit program!



i must buy a bigger laser at the end

This shouldn't make much difference as the current draw is tiny, so the volt drop should also be tiny.

Ian

[mccarrot]

The biggest voltage losses (0,1V) I find in on those F@#@%#%^@* Sub-D connectors.

I vote for ILDA2.0, and get rid of the crappy sub-D connectors.

[sbk]

Your best friend

[carlos3621]

or, you can get the .NET interface, and place the DAC within inches of your projector.
And run CAT 5 from your computer to the DAC!

[mccarrot]

I Use QM.nets, but even with a short cable I have losses on my Sub-D.