
Originally Posted by
Greg
snip
MYSTRY is probably the spinning boxes one. It takes two inputs which I have to guess at. (1) It loads a value from $EE which is not documented or used anywhere else. It also performs a BIT instruction on $07FF which maps to the end of the P7 BLU DAC, according to the memory map in the documentation. By externally sweeping the $EE input 0 through 255 and roll, the output produces a sinusoid on one axis. Maybe the BIT test is used to read a pulse train, as that input appears to switch the output between one of two offsets on the other axis. These inputs must relate somehow to Ron's comment about the time the routine was entered serving as parameter.
snip
There weren't enough 351 bits available for all the different Dog stuff, so there were three switches added to the remote panel - two switches to select between 4 posibilities and one switch that inverted y axis output. The 352 card was introduced to distill the 3 - 351 decoder boards down to one board. This was done so up to 2 more dmux boards could be added to get 32 more select bits. This was done concurrent to the installation of the ADIG box. (accessory digital image generator) There was a key pad added to the control panel that let the Laserist interact there too. The ADIG signal was wired to the fixed cycloid select switch.
"Bad art is a great deal worse than no art at all." - Oscar Wilde